@Wizza HMD are made by label, add a curvature to the label with the camera as the center, and text moves vertically through this. Horizontal movement of the text is done by rotating the entire label via the joystick base. The locking box is calibrated through the second cockpit.
@Rakoval500k This can be difficult for hairs of mod programmer, lol, but the easiest way to do this is to add an automatic trim by using PitchRate integral.
@iPilot Navigation system basically based on Leehopard's Fc-912C, I added some fancy display. Some buttons with the same function are placed in different places, just for operate quickly. Waypoints preset at LatLongairportAltairportHdg now, but I haven't thought of a good way to add this in cockpit.
@skittleChan I don't have my laptop around now so I can't do this.
But check this: part id 6619, a green 'ControlBase-Joystick-1', under the pilot seat cushion, is connected to HMD.
@421stFighterSquadron It's free, but it could be tricky because there are a lot of ralated variables involved in hud, it is not a good enough '1 part hud' I think
@ollielebananiaCFSP Yes, I use PlanariaLab's SP Label Converter program to import islands.
This map's actual performance cost is around 4000~5000, kind of bad.
Human has different tolerances to the positive and negative Gs, if could set the positive and negative lower/higher G tolerance separately would be better.
It sometimes reach 17G (or over 20G at supermaneuvrability mode) at high speed, G limiter should do a little tweaking.
And about Mach, I think TAS/sqrt(1.4*287*(273+(15-Altitude/1000*6))) is more accurate.
Small update :
Improved yaw stability
Reduce assist turning effort
8/26/2023
Improved FCS and flight model
12/25/2023
Simple but fun enough, I could drive it across the map :-)
+1@lastcentury 是的，别看零件少，实际性能占用在4000~5000，相当于一千多个零件，因此并不推荐使用这个试验版地图。之后我有空还会再优化一下。
@MobileBuilder21 Restored ✓
+1@windshifter1 And the img about runway, I'm not sure which map was used
@windshifter1Edwards-Air-Force-Base-California
Nordschleife
@windshifter1 And my laptop can't actually use the reshader either, so most of the pictures were taken by my friend.
@windshifter1 Sometimes reshader is not necessary, such as first vertical image and the fourth and fifth pictures from the bottom haven't use reshader
@windshifter1 Reshader + Low FOV + PS
+1@Wizza HMD are made by label, add a curvature to the label with the camera as the center, and text moves vertically through this. Horizontal movement of the text is done by rotating the entire label via the joystick base. The locking box is calibrated through the second cockpit.
@girlsandpanzer 我把停在地面时减震器的压缩量考虑进去了，并按照飞行状态+目测来估计压缩量，所以在机库看起来会比一般的三视图上的长一些，进了游戏整架飞机的重量压上去就是正常大小。不过如果确实哪里做大了的话我可以再改改。
+2@gusbus1234 lol, but GuyFolk is making the F-35, just wait a while
@iPilot Yes, it is absolutely feasible, basic waypoints information store in
+1LatLongairportAltairportHdg, just modify them by entering coordinates@Wiksi123 About fps, u can try the 999 parts vertion, my phone could run with about 60fps
@Wiksi123 Keep ratio, such as 0.1,0.1,0.1, and u can only shrink it, but couldn't make it invisible.
@Wiksi123 It depends on what you want, but basically default setting is enough to me
@Rakoval500k This can be difficult for hairs of mod programmer, lol, but the easiest way to do this is to add an automatic trim by using PitchRate integral.
@iPilot Navigation system basically based on Leehopard's Fc-912C, I added some fancy display. Some buttons with the same function are placed in different places, just for operate quickly. Waypoints preset at
+1LatLongairportAltairportHdgnow, but I haven't thought of a good way to add this in cockpit.@GuyFolk lol, thx u for enjoying this, and looking forward to ur F35 !
+1@ZeroWithSlashedO In fact, 999 parts vertion has lowest actual performance cost because there is no cockpit.
@windshifter1 The screenshots were made by IanYashima
@Wiksi123 The mod 'Overload' could easily modify such as scale, drag, mass, health...etc
@Wiksi123 Use a mod called 'Overload'
@Wiksi123 Reduce the scale of the smoke generator and hide it, and enlarging the smoke scale by the same magnification
@skittleChan I don't have my laptop around now so I can't do this.
+1But check this: part id 6619, a green 'ControlBase-Joystick-1', under the pilot seat cushion, is connected to HMD.
@TimsonAviation Basically use default setting and original scale is ok
@KOROaviation Screen recording→Photoshop→GIFS
@hucike 导弹发射程序还是有些复杂的，确实有几率会受到游戏内不稳定因素的干扰（例如发射顺序被随机调换），这个我也没有办法，只能说大部分情况下是正常的
@skittleChan It's free, but it could be tricky because there are still a lot of ralated variables involved in HMD
+1@F8boa No, haven't gun, missiles only
Smoke-Trails
@Wiksi123 That's a mod called 'Smoke Trails' , just for video
@TimsonAviation Smoke trails is a mod, the color of the smoke trails can be changed via the Trim 1 paint color for the nozzles
@Ole97466 Download this mod: www.simpleplanes.com/Mods/View/486932/Smoke-Trails
+1@DFA007 Just try 999 parts vertion, that is made for phone
+1@FalconDynamics lol, I might need a more powerful PC
@421stFighterSquadron It's free, but it could be tricky because there are a lot of ralated variables involved in hud, it is not a good enough '1 part hud' I think
@dhtv587 任意字符都行吧，反正透明度改0就看不见了
@dhtv587 在标签上下位置各放一个透明字符作为上下限，其余内容的活动不超过该上下限就行了。还有行间距貌似也有一点影响，记不太清了，可以试试。
@Super737 不用的，可以随意使用
+1@363636 我以前也用iOS，是通过越狱后安装文件管理器来改xml。不过现在没在用iOS了，不知道是否还能这样弄
@363636 About copy variables, I recommend doing it directly in the .xml file, rather than in the game, could saves a lot of hassle like what u meet.
@Ian_Yashima 还是发点东西哈哈，不过还没做完
+1Very interesting! I even didn't know the joystick base can parallel movement until download this.
@TheCommentaryGuy A replica fighter of the 5 generation
@ollielebananiaCFSP Yes, I use PlanariaLab's SP Label Converter program to import islands.
This map's actual performance cost is around 4000~5000, kind of bad.
@Gastonplanes You can search
+1maw, and adjust Maywar'stransparency "FF" to "00", but don't remove it.
@jamesPLANESii Ok, published now,haha :)
+3Human has different tolerances to the positive and negative Gs, if could set the positive and negative lower/higher G tolerance separately would be better.
+6It sometimes reach 17G (or over 20G at supermaneuvrability mode) at high speed, G limiter should do a little tweaking.
And about Mach, I think
TAS/sqrt(1.4*287*(273+(15-Altitude/1000*6)))is more accurate.