@SimplyPlain No problem, it's probably the length, you should never use different values in the exhaust scales, changing the engine's max would do the job.
One of my favourite aircraft, really nice replica, good job!
.
I've noticed some flaws though:
- AG6 only detaches the left pylon.
- The engine's exhaust scale (without afterburner) is a bit messed up.
Other than that it's pretty nice.
@asteroidbook345 I probably messed up with the booleans, try this:
clamp01(Activate3) * clamp01(GS>15.4333) * clamp01(GS<66.8778)Congrats, you mentioned me 4 consecutive times, have a cookie.
@asteroidbook345 Oh wait, I just saw you are putting it in the ActivationGroup, and not in the input.
@asteroidbook345 My formula is finished and ready to use.
@asteroidbook345
Oof.
That's not what I said.
It would be
clamp01(Activate3) * clamp01(66.8778>GS>15.4333)@SimplyPlain No problem, it's probably the length, you should never use different values in the exhaust scales, changing the engine's
maxwould do the job.One of my favourite aircraft, really nice replica, good job!
.
I've noticed some flaws though:
- AG6 only detaches the left pylon.
- The engine's exhaust scale (without afterburner) is a bit messed up.
Other than that it's pretty nice.
@Hedero Thanks! :)
What James said, it doesn't work on any version older than iOS 13.
⬇️
@GentonGengar Thanks! I'm glad you like it. :)
This is quite fun, lol.
Thanks, @QingyuZhou :)
@ChisP Thanks and congrats, kek.
Normally I start with the nose and then I finish the fuselage, make the wings (and tail), landing gear, and finally the flight model.
Specs:
CPU: Ryzen 5 3600
MOBO: B450 Gaming Plus MAX
GPU: GTX 1660 Super
RAM: 2x8Gb DDR4 3200mhz
PSU: Corsair CX550 80+ Bronze
STORAGE: SSD 1Tb 2.5"
lol