[HELP NEEDED] 3BL Leyland Olympian WIP 1 Front
7,981 ChallengerHellcat
4.2 years ago
No Tags
Auto Credit Based on ChallengerHellcat's 3BL Leyland Olympian WIP 1 Front
Problem shooting- Can someone tell me why my cockpit is at -0.0055 and not at 1? I've tried connecting and reconnecting almost everything. However, the last time I checked I think there was something to do with the piston powered headlights: when I deleted it the imbalance was gone.
Any help would be much appreciated.
Specifications
Spotlights
- Inuyasha8215 2.2 years ago
General Characteristics
- Predecessor 3BL Leyland Olympian WIP 1 Front
- Successors 3 airplane(s)
- Created On Mac
- Wingspan 8.3ft (2.5m)
- Length 39.1ft (11.9m)
- Height 6.5ft (2.0m)
- Empty Weight 7,851lbs (3,561kg)
- Loaded Weight 9,513lbs (4,315kg)
Performance
- Power/Weight Ratio 28.346
- Wing Loading N/A
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 6333
Parts
- Number of Parts 332
- Control Surfaces 0
- Performance Cost 1,368
Thanks! @DickBrazen
@ChallengerHellcat I don't have it anymore, but it was either the floor of the driver's area or the wall behind the seat of the driver's area that was sticking out too far. I'll download this again and see about fixing it if you want, but somebody downloaded that bus. It must've been someone who saw this post.
Sorry, but can you upload an unlisted post of my bus again? I didn't download it last time. @DickBrazen
I found the problem and tagged you in the post. I don't mind if you change the url code to remove my credit because you're doing so well on this and I don't deserve that much credit. I'm not sure what the mods and devs will think of that, but I don't mind.
OOhhh. Thanks a lot. @DickBrazen
Haven't done it yet, but if you look in the very back of the bus, the furthest back center piece and the one on the underside furthest back are set at .0070 instead of -0.0055. This is probably causing the pieces surrounding it to get thrown off center.
What I'm going to try to do is use multiselect. First I'm going to select everything that I know should be centered at 0, then everything else after that, switch it all to 0, then compare each side until I find the ones that are off.
If you haven't thought of that, you'll probably get results doing it yourself sooner than I can get back to you.
Found it. I'll try to help.
I can't even find the cockpit?
Probably there’s an obstacle that doesn’t make it to 1.This is just my opinion,after,I don’t know.