Profile image

VTOL jet-powered helicopter-plane

26.5k Wibbley  1.3 years ago
Auto Credit Based on Wibbley's Rouundyshit Vt 3






Instructions in the comments
/READ THEM PLEASE/

Spotlights

General Characteristics

  • Predecessor Rouundyshit Vt 3
  • Created On Android
  • Wingspan 62.4ft (19.0m)
  • Length 22.9ft (7.0m)
  • Height 65.1ft (19.9m)
  • Empty Weight N/A
  • Loaded Weight 12,577lbs (5,704kg)

Performance

  • Power/Weight Ratio 2.68
  • Wing Loading 8.1lbs/ft2 (39.4kg/m2)
  • Wing Area 1,559.4ft2 (144.9m2)
  • Drag Points 28551

Parts

  • Number of Parts 232
  • Control Surfaces 10
  • Performance Cost 1,519
  • Log in to leave a comment
  • Profile image
    26.5k Wibbley

    Управление
    1) наклон лопастей
    (Они работают с помощью реактивных двигателей, могут отклоняться на 160°, также оснащены тормозами)
    2) вроде ничего
    3)стойки
    4)гироскоп для экстренной ситуации (обычно он не нужен)
    5)гироскоп
    6)двигатели кабины
    7)отделение кабины от фюзеляжа


    Инструкции


    Для взлета:
    +Активируйте 1 и Опустите VTOL вниз, чтобы направить лопасти назад
    +Активируйте гироскоп(5)
    +Прибавьте тягу на 100%
    +Активируйте 3, дождитесь, пока стойки уберутся, затем деактивируйте
    +уберите шасси
    +деактивируйте гироскоп(5)
    +пока самолет переворачивается, поднимите VTOL вверх и выровняйте самолет
    +файналли вы взлетели


    Посадка:
    +Активируйте 3
    +Поднимитесь ровно над полосой(метров 200)
    +Опустите VTOL
    +направьте самолет вниз
    +Активируйте гироскоп(5)
    + Снижайтесь, регулируя VTOL
    +после касания  приведите VTOL в нейтральное полодение, сбавьте тягу и тормозите

    Отделение кабины от фюзеляжа в экстренных ситуаиях

    +Активируйте 7
    +Поднимите Trim
    При необходимости используйте реактивные двигатели (6)



    Management

    1) tilt of the blades
    (They work with jet engines, can deviate by 160°, and are also equipped with brakes)
    2)nothing
    3)racks
    4)hyroscope for emergency
    5)gyroscope
    6)cabin engines
    7)separation of the cabin from the fuselage.


    Instructions
    For takeoff:
    +Activate 1 and lower the VTOL down to guide the blades backwards
    +Activate the gyroscope(5)
    +Increase throttle by 100%
    +Activate 3, wait until the racks are removed, then deactivate
    +press button: LandingGear
    +deactivate the gyroscope(5)
    +While the plane is flipping, lift the VTOL up
    +fainally you took off


    Landing:
    +Activate 3
    +Rise exactly above the the place, where you want to land (200 meters)
    +Lower VTOL
    +point the plane down
    +Activate the gyroscope(5)
    +fly down slowly by regulating VTOL
    +after touching t̶h̶e̶ ̶g̶r̶a̶s̶s̶ the ground, bring the VTOL to a neutral position, slow down the thrust and brake


    Separation of the cabin from the fuselage in emergency situations
    +Activate 7
    +Raise Trim
    If necessary, use jet engines (6)

    Pinned 1.3 years ago
  • Profile image
    26.5k Wibbley

    @ShinyGemsBro :)

    1.3 years ago
  • Profile image
    34.3k ShinyGemsBro

    This has got to be the most unconventional design I've ever laid my eyes on and I'm all in for it

    1.3 years ago
  • Profile image

    @Wibbley The propellers inside of a tube with a spike coming out the back made me think it was a flying engine concept.

    1.3 years ago
  • Profile image
    26.5k Wibbley

    @TheEpicTrains3rdAccount it's not flying engine or flying wing

    1.3 years ago
  • Profile image

    The flying wing concept has nothing on the flying engine concept

    1.3 years ago
  • Profile image
    26.5k Wibbley

    Thank you for upvotes

    1.3 years ago
  • Profile image
    26.5k Wibbley

    @xNotDumb thank you!

    1.3 years ago
  • Profile image
    29.5k xNotDumb

    Great Concept!

    +1 1.3 years ago