In case you didn't know, I announced that I was going to make an airport for Maywar, and so far it is going good! In fact, I'll share with the community some screenshots!
NOT SO FAST THERE, BUDDY!
Even though it looks like it is done, it is not. Can't tell? Look at this picture.
THIS
is what the airport and Maywar look like in the daytime. Isn't it really bright? I can't figure out what is wrong in unity, and I have no directional light in the editor. Does anyone know what to do to make this less bright? Cause I don't know.
ALSO
Whenever I try to land any of the runways, I just sink right through them, as well as the hangars, barracks, and the tower. And I've tried many different collider components, but none have worked. And the ground is slippery, the only way to stop is using air brakes or reverse thrusters, and I can't turn on the ground. Please take note that the sooner I get help means the sooner the mod will come out!
That's all for this teaser! If you want to be tagged on the mod post, comment "Maywar"! And please leave me any suggestions in the comments as well!
Aircraft in first picture
Aircraft in the second picture
Aircraft in the third picture
Aircraft used in fourth picture
EDITS:
(as of 9:00PM EST Mar 31)
Light problem fixed
Runway Problem partly resolved, Still can't brake and turn on either the runways or the ground.
Np @Lahoski107
@USSR THANKS
@Lahoski107 O H M Y
@KingHandspider I was jk
@Lahoski107 oh my
@ErvenDynamics Bagram as a whole is a ■■■■■■■■
jk
@KingHandspider Thank you! You honestly saved me from jumping off the bridge.
@Lahoski107 No, go to the area above the the Transform area in the inspector, and set the Layer to "Terrain". Everything should have its own box collider.
Also, just make your own PhyiscMaterial, and call it "Asphalt". Change the two frictions to 1, don't change anything else. I would recommend just leaving the bounce settings alone, as the default is pretty much good for this application.
@KingHandspider so set the runways and taxiways to "Terrain Collider"? Also, what do I set the bounciness to, as well as the bounce combine? And I can't find the Asphalt physic material anywhere. Can you send me a download link or let me know where to find it?
Give the colliders of the things you want to be asphalt-y a PhysicMaterial with both frictions set to 1, and the friction combine set to "multiply".
Also, set everything's layer to "Terrain".
@ErvenDynamics DO NOT TALK ABOUT BAGRAM!
@Zoomzoom999 will do, and will do, I’m going to add more Barack’s and hangars, planning to put the tower in the middle of a barrack, and make it smaller.
Add a bridge from the airport to Maywar. Also move the tower somewhere else
MAYWAR
@WNP78
@ErvenDynamics the runways are glossy because of the unwanted brightness
I’m just going to keep the runways how they are but maybe add a few taxiways and hangars
@Aerofy there isn’t a directional light for all I know.
@Lahoski107 Did you remove the directional light? If yes, Maybe it still exists under the map plugins dropdown in the inspector.
@AchuTMM since there is no maywar on mobile, no airport for mobile, sorry :(
@Tully2001 there is no directional light.
@MisterT what component?
Set your shader to "legacy diffuse" if it's too bright.
that control tower is way too close to the runway