Profile image

Plane power by a Cannon

9,129 oldmate52  5 months ago
Auto Credit Based on TheMouse's Alternate energy challange [CLOSED]

Thats not an engine at the back thats cannon with a lot of recoil. This plane is then fast can get (mach 10) but riskes blowing up. Flyers at about mach 2 a lot better and doesn't blow up when at mach 2.

It is also very good for passing the going the distance challenge in about 30 seconds I got to 100,000 feet.

I flew from wirght airport to avalanche airport which is about 80 miles in under 5 minutes.

To fly go to the weapons tab and fire one shot to take off then fire on shot ever couple of seconds and to keep your speed about 1000 to 1750mph you can go over 8000 mphs (mach 10) but you risk blowing up or losing control. Don't say I didn't warn you.

General Characteristics

  • Predecessor Alternate energy challange [CLOSED]
  • Created On iOS
  • Wingspan 37.1ft (11.3m)
  • Length 28.4ft (8.7m)
  • Height 9.8ft (3.0m)
  • Empty Weight 4,619lbs (2,095kg)
  • Loaded Weight 4,619lbs (2,095kg)

Performance

  • Wing Loading 31.1lbs/ft2 (151.7kg/m2)
  • Wing Area 148.7ft2 (13.8m2)
  • Drag Points 1639

Parts

  • Number of Parts 20
  • Control Surfaces 5
  • Performance Cost 152
  • Log in to leave a comment
  • Profile image

    Lol

    +1 2 months ago
  • Profile image
    9,129 oldmate52

    @Jjjohnson yeah it goes very fast

    2 months ago
  • Profile image

    Just don’t put it back to normal speed or it will pop.

    +1 2 months ago
  • Profile image

    I put this one into slow motion and I got it up to 130.000 mph. It was still going up comfortably, but it also went a little bit into high orbit.

    +1 2 months ago
  • Profile image
    9,129 oldmate52

    @Mousewithamachinegun123 thanks for the suggestion I will try that.

    5 months ago
  • Profile image
    35.7k TheMouse

    Look-9/10
    Flying-5/10
    Special-4/10
    Range-7/10
    Propulsion-6/10
    Total-31/50
    Good job!
    Also, a suggestion. To make a cannon plane not blow up, you must make it incapable of going up to a speed where it does blow up. To do this, set the drag on some of the pieces up to higher, and then set the recoil force to slightly lower. If you spend a bit of time working on this, then you can get a fairly accurate top speed. Thanks for joining!

    5 months ago