THIS IS A REQUST from standardCookie
.
Instructions
Drag into your subassemblies
.
Connect the bottom detacher's Lower attachment point to the fuselage or cockpit (not the actual cockpit computer)
Next, change scale of Flight Computer to .1 , .1 , .1
Next , put the Flight Computer inside the the pilot's stomach and make a manual connection
.
Canopy Connections
Connect a detacher to your canopy. Set the delay to zero, force at 25%, and use Activate 7
Next, go into the settings of your canopy and set dragScale to 0 & massScale to .1
That should do it. Z👍 😺
.
Note
The only part of this entire assembly that should connect to your aircraft is the lowest detacher.
the flight computer must go in the pilot's stomach or the system will not work correctly
.
Finally
Use activate 7 for your eject button., all of the various components use activate 7 in order to operate.
Enjoy
Z
Special thanks to Guyfolk for the programming inside the rocket
Thanks to ICECRAFTGAMING for the actual pilot
Specifications
General Characteristics
- Created On Android
- Wingspan 1.9ft (0.6m)
- Length 7.2ft (2.2m)
- Height 4.7ft (1.4m)
- Empty Weight 2lbs (1kg)
- Loaded Weight 2lbs (1kg)
Performance
- Wing Loading N/A
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 2
Parts
- Number of Parts 1
- Control Surfaces 0
- Performance Cost 282
@RaptorAerosystemsCorp Not a bad idea. Have you seen the Automatic Reserve parachute ? If you are falling w no chute, it will automatically deploy Click here to see Z 😺
@Graingy Lol....I could see that....Z 😺
For a moment I thought that was a toilet...
Well, at least it helps you step outside to take a leak.
Getting back in, however...
@standardCookie connect a detacher to your canopy. Set the delay to zero, force at 25%, and use activate 7. Next, go into the settings of your canopy and set dragScale to 0 & massScale to .1 That should do it. Z 👍 😺
thanks
@standardCookie