This is @TheRealSavageMan’s UH-60M Blackhawk Model/Build, decided to switch it up a bit, Took a couple of parts off on the Original UH-60M, and attached SH-60 parts. Since the main Build itself is modelled after the UH-60M, and has big differences between the latest SH-60 and UH-60 variants, I decided to name it SH-60M, I’ll only take credits for the work I did on it, the Rest of the Credits goes to mate who built the UH-60 model and to other lad who built the parts of the SH-60.
UH-60- @TheRealSavageMan
SH-60- @2Papi2Chulo

checkout @2Papi2Chulo’s SH-60 as well

Controls
AG1 to turn on rotors
AG2 to reach max speed
AG3 for lights
AG4 to Open Rear Doors
AG5 to deploy the Winch
AG7 for parking brakes
LandingGear to Open Cockpit Doors
VTOL Up to Extend the Fuel Probe

(P.S I recommend you push the trim +1, to stabilise the helicopters pitch After takeoff. After takeoff the rear part is pulling down, havent checked what may have caused it yet.)

Figured out what was causing the Helicopter to Tilt backwards, Center of Gravity is a Little off, tail is much heavier than the front I guess. So anyways, what I did was Add an additional 500 lbs on each sides which are PARTs of the main CHASSIS then added an Extra 250 lbs Under the Cockpit to be specific Outside then below the cockpit. so 1250 lbs in Total. Enjoy