So, i made this pile of rubish plane for testing a 3D thrust vectoring system. It definitivaly does work fairly decently, but some problems are extremely annoying.
1: When spawned in, the right engine is behind the one the left. Spawn this in at low physics (i didnt test on any others cause i can only run low physics) and you will see what i mean.
2: I cannot get the engines to fully take air, no matter how many intakes i place down. This is the best i got with 4 intakes (2 fuselage and 2 XML modded slim inlets).
This was annoying to make too, beacause it is basically imposible to do it like this with no mods. I needed to use Designer Suite and Overload quite often here and to the full extent of my abilities. Anyway, if you have anyway of making this better please do so, as ive been wanting to make this perfectly for quite a while now and any help would be amazing.
Thanks for checking this out!
Note 1: Not my actual description format.
Note 2: I know this is not groundbreaking and already quite done before, but i never made one myself so yeah.
Specifications
General Characteristics
- Created On Android
- Wingspan 27.6ft (8.4m)
- Length 33.9ft (10.3m)
- Height 8.1ft (2.5m)
- Empty Weight 11,123lbs (5,045kg)
- Loaded Weight 23,360lbs (10,596kg)
Performance
- Power/Weight Ratio 2.885
- Wing Loading 86.8lbs/ft2 (423.9kg/m2)
- Wing Area 269.1ft2 (25.0m2)
- Drag Points 2079
Parts
- Number of Parts 25
- Control Surfaces 6
- Performance Cost 300
@Mobius1Cyka
np m8!
@SakuraSaku thanks fam! If i even tried with the looks it would look better but as its a test bed, looks dont matter to me in tgis thing. But anyway, thank you for the compliment once again!
looks awesome!
@D2XD2 sure, feel free to upload it. Thanks!
Basically it thinks the engines are disconnected from the plane, so you gotta put the inlets on the actual jets. I can upload if you want.
Hey i fixed the inlet issue.
@avataxel thank you fam!
super, frankly me I tried to do something like that and I was less successful than you frankly gg