My experimental cannon that i am going to equip on my jet! Yes, it is a teaser for an upcoming plane. The crazy thing is that this thing is gonna have auto aim! FREE TO USE JUST COMMEND ME THANK YOU :)
edit: Im planning to make this plane unnecessarily overpowered so... if you guys have any better auto-aim code, feel free to comment it
Specifications
Spotlights
- SPairforce 2.4 years ago
- LarryTad 2.4 years ago
- MrCarrot 2.3 years ago
General Characteristics
- Created On Android
- Wingspan 18.0ft (5.5m)
- Length 15.4ft (4.7m)
- Height 9.8ft (3.0m)
- Empty Weight 3,776lbs (1,713kg)
- Loaded Weight 3,776lbs (1,713kg)
Performance
- Wing Loading N/A
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 4445
Parts
- Number of Parts 60
- Control Surfaces 0
- Performance Cost 226
@JasonVorrhees Ah ok
@IceCraftGaming I found it was easy to get it as a subassembly just make the blocks above to the gun invisible after move that cockpit block to the base of the what's holding the gun
@JasonVorrhees I'm not sure how to make this one have auto aim and I also find it difficult to find the point to hold to make it a subassembly
@IceCraftGaming what's the issues
@JasonVorrhees none so far. This particular cannon has a couple issues I'm trying to figure out.
What plane did you put this on
@NobleMobileUser oh ok
@IceCraftGaming Ah thanks but I probably wont I already uploaded the plane and then again for a challenge. Plus the thing is pretty meh anyway sooo.
@NobleMobileUser cool!
I'd love to check it out once its released
(if it does)
@IceCraftGaming I acommplished it, but it makes the plane less manueverable. It does, however, fix its lack of serious firepower, by alot.
@NobleMobileUser be careful with it because I had a difficulty finding the part to hold for a subassembly.
This weighs as much as the plane Im going to put it on but here goes
@Falco7 thanks for the tip
Lookin good. Little tip, if you want higher fire rate from cannon then use more of them. I think there is a limit to firingDelay despite input value being 0