@Jim1the1Squid it's good as is, the wing placement is just fine on the normal version of the aircraft. Plus I made the elevators do that SO it could flip and such.
@Noname918181 it's only a tiny bit too close when pulling as hard as possible without the rotating elevator at low speeds. It's doing this cause the entire rear wings are rotated lmao
@Jim1the1Squid This was really the only time I made a flippy jet, so probably
So you like drifting jets?
@Jim1the1Squid it's good as is, the wing placement is just fine on the normal version of the aircraft. Plus I made the elevators do that SO it could flip and such.
The CoM needs to be in front of and below the CoL otherwise what that jet did will happen 24/7.
@Noname918181 Aircraft 3 AA, I'll check to see if its uploaded or not
So what is the name of the plane
@Noname918181 oof x2 (well, 4)
@MephilesTheDark oof
@Noname918181 oof
@MephilesTheDark oof
@Noname918181 it's only a tiny bit too close when pulling as hard as possible without the rotating elevator at low speeds. It's doing this cause the entire rear wings are rotated lmao
The CoM is basically too close to the CoL