I have another tip not involving the rotators but the custom fan inside your engine:
If you set it to maxRpm = 100 it won't go 'transparent' from spinning (if you know what I mean)
“This increases the damper. This is very useful for rotators that wobble when you move them. To remove wobble, increase this in powers of 10 (10,100,1000) until it stops wobbling. Too much damper will cause it to rotate too slowly.”
Taglist:
@ToastedRainbowSandwich
@griges No problems 😊
@JBPAviation thanks for the info!
@griges no in fact, I use it a lot to prevent blades from braking.
@JBPAviation wait... i can lower maxrpm? so blades spin slower?????
all this time i thought it was the max rpm of the blade before it breaks
I have another tip not involving the rotators but the custom fan inside your engine:
If you set it to
maxRpm = 100it won't go 'transparent' from spinning (if you know what I mean)Quoted from WNP78:
“This increases the damper. This is very useful for rotators that wobble when you move them. To remove wobble, increase this in powers of 10 (10,100,1000) until it stops wobbling. Too much damper will cause it to rotate too slowly.”
sorry late reply
@HungrySu34
https://docs.google.com/document/u/0/d/e/2PACX-1vRaoCHndg9exQh4sw5Re88dR2TmR3YeLQdLbNL8sg-W-CuK7lL65iMlqpoNUjVLXbPxk5TdAdlmWRyV/pub?pli=1
i found that, the joint rotator does wobble
but adding
damperMultiplierby 10000 kinda make it better, but make the nozzle slow.
so, either adding damper multiplier, and increase speed a little.
or, i think its better to change to rotator thats safer
@griges here
is there a video? or can i see
@griges still wobbles
@HungrySu34 then try give the rotator mass back?
@griges i set it to 0 mass
i thought it was clickable,
@HungrySu34 wobble from the hinge?
did you re-scale mass ? or set 0 mass?
@JBPAviation no,it's a custom engine,the back thingy keeps wobbling
Is it a ww2 prop?