By any chance has anyone experimented with incremental flaps that can go up and down on a set of two buttons (one for moving up an increment and one for down)? I have a build about ready to launch but making this very specific German flap system has been a pain.

On the math end, my guess is somehow I need to make these buttons subtract or add 0.33 to the flaps axis. But frankly I’m not sure how to pull this off... buttons work on a ON/OFF fashion and don’t really do push function. Even if this push function did work, the number needs to be stored so if you press it again it adds another increment. Then you can clamp and smooth the output number so it doesn’t over extend the flaps.

I fear it might be the case that what I’m trying to do is just not plausible in SP right now and I’m better off just making a flaps lever.