(just FYI this is on the Questions forum I put it here too since I didn't know which it belongs to so I put it in both)So we all know and love the little what I like the call the "nudge" tool so we can clip parts into each other and rotate parts well I have stumbled across an issue that needs fixing and idk if this is supposed to go in Mods or Questions so ima put it in both but I get two parts that both need to be 0.886 degrees on the y-axis and the little nudge tool does the job and says there both 0.886 on the y-axis but I double check with the fine tuner mod and there actually 0.886226 and 0.885999 which normally wouldn't be a big problem it's just a 0.000227 degree difference but with my situation that 0.000227th of a degree difference between the two has cost me over 3 hours of build time because of how small and precise this has to be I'm on mobile so I can't show how big an issue this has been but I hope to still get some help for my issue

Thank you for reading this all have a wonderful flight filled day